General Purpose Epoxy Putty
Eazy Seal is an epoxy resin based sealant supplied in putty consistency, extruded in a premeasured stick form ensuring right mixing ratio.
Properties
| Resin | Hardner | ||
|---|---|---|---|
| Type of Compound | Filled epoxy resin compound | Filled hardner compound | |
| Color & Appearance | Green Stiff Putty | Black Stiff Putty | |
| Penetrometer reading 24h / 25°C | Mm | 6.0 – 6.5 | 6.0 – 6.5 |
| Setting time of Resin + Hardner at 25°C |
Minutes | 90 – 120 | 90 – 120 |
| Ash Content | % | 75 – 80 | 75 – 80 |
| Shelf life | Months | 12 | 12
|
Eazy Seal sealing system is characterized by
- Excellent adhesion to almost all materials like metals, wood, glass, ceramic and most plastic
- Ease of application
- Good mechanical and electrical insulation properties
- Good moisture and chemical resistance
Mixing Proportion
| Eazy Seal Resin | 100 parts by weight or volume |
| Eazy Seal Hardner | 100 parts by weight or volume |
- Cut required quantity along with the film for the cocentric stick
- Twist and knead (action not exceeding over 1 minute) to a uniform color
- Repairs should be done before hardening (usually within 3 minutes)
- Place the remaining quantity in the canister and close the cap for future use
Processing Time
- Pot life at 25°C : 30 minutes
- For 500 g mixture
- Setting time : 120 minutes
Recommended Curing
- For optimum cured properties
- at 25°C 24 hours
- or at 30°C 12-16 hours
- or at 40°C 4-8 hours
- Eazy Seal will cure to hard mass within 3 hours at room temperature.
Surface Preparation
- For better adhesion, it is essential to clean the surface on which Easy Seal is to be applied.
- Remove rust, dirt or loose particles by emery paper or wire brush. Use rust remover for removing heavy rust and scales.
- All surface must be free from oil and grease. Use rust remover, and / or trichloroethylene.
- Surface should be free from moisture to get optimum performance. Wipe with dry cloth before application.
Properties of Cured Eazy Seal
| Cured for 24 hours at room temperature | ||
|---|---|---|
| Tensile Strength | kg /cm2 | 190 |
| Flexural Strength | kg/cm2 | 320 |
| Impact Strength | KJ/m2 KJ/m2 |
4.0 3.5 |
| Compressive Strength | kg /cm2 | 60 |
| Heat distortion temperature | °C | 40-45 |
| Volume resistivity at 1000v DC | ||
| a) At R.T b) After 24 h immersion in water |
ohm.cm ohm.cm |
6.0 x 1012 5.0 x 109 |
| Dielectric Strength at room temperature | ||